Channel Search; Clear Service List; First Time Installation - Finlux 22FLD842 Bedienungsanleitung

(*) For Denmark, Sweden, Norway or Finland.
Auto Channel Scan (Retune)
Auto Channel Scan (Retune) is started by pressing
"OK" button while Auto Channel Scan (Retune) item
is highlighted.
The following message appears on the screen:
Highlight Yes or No by using " " or " " buttons and
press "OK" button to confi rm.
If Yes is selected, automatic search starts.
Selecting No cancels automatic search.
After search is completed for digital channels, a
message asking whether to search for analogue
channels appears on the screen:
Press the "OK" button to search for analogue
channels. The following menu appears on the screen
for analogue channel search:
Select your Country , Language and Text language
by using " " or " " and " " or " " buttons. Press
"OK" or RED button to continue. To cancel, press
BLUE button. The following menu will be displayed
during the automatic tuning:
A02_MB46_[GB]_1205UK_IDTV_NICKEL15_22841W_10069458_50170499.indd 50 A02_MB46_[GB]_1205UK_IDTV_NICKEL15_22841W_10069458_50170499.indd 50
After APS is fi nalized, the programme table will appear
on the screen. In the programme table you will see
the programme numbers and names assigned to the
programmes.

Channel Search

In manual channel scan, the number of the multiplex is
entered manually and only that multiplex is searched
for the channels. For each valid channel number, signal
level and signal quality are shown on the screen.
In both manual and auto search any existing channel
in the database is not re-stored to avoid redundant
duplicates of that channel.

Clear Service List (*)

(*) This setting is visible only when the Country option is set
to Denmark, Sweden, Norway or Finland.
Use this setting to clear channels stored. Press " " or
" " button to select Clear Service List and then press
OK. The following OSD message will be displayed
on the screen:
Highlight NO and press OK to cancel. Select Yes by
pressing " " or " " button and press OK to delete all
of the channels.

First Time Installation

The user can use this item to load default settings,
which were loaded to the receiver at the factory.
To install factory settings, highlight "First Time
Installation" menu item and press "OK" button, then
you will be asked whether or not to delete the settings.
Selecting "Yes" by pressing "OK" button while "Yes" is
highlighted will delete the existing channel table.
Then you will be asked to confi rm for deleting all
channels and settings:
By selecting Yes and pressing the "OK" button, the
existing channel table will be deleted. After factory
settings are loaded, "First Time Installation" menu
will be displayed.
The menu which is displayed for language selection
appears on the screen at fi rst. By using " " or " "
English - 50 -
04.08.2010 17:07:59 04.08.2010 17:07:59