Menu System; Picture Menu; Colour Temp - Finlux 37FLHD760 Bedienungsanleitung

Obtain the Conditional Access Module (CAM)
and the viewing card by subscribing to a pay
channel company, then insert those to the
Television using the following procedure.
• Switch off the TV and unplug from the mains.
• Insert the CAM, and then the viewing card to
the slot that is located in the terminal cover
at the left-hand side of the TV (from front
view).
• The CAM should be correctly inserted, it is
impossible to insert fully if reversed. The
CAM or the TV terminal may be damaged if
the CAM is forcefully inserted.
• Connect the TV to the mains supply, switch
on and then wait for few moments until the
card is activated.
• Some CAMs may require the following set
up. Please set the CAM by entering the IDTV
menu, Common Interface then pressing OK
button. (CAM set up menu is not displayed
when it is not required.)
•To see the viewing contract information:
• Enter IDTV; press M button, then highlight
Common Interface and press OK button.
• When no module is inserted, "No Common
Interface module detected" message
appears on the screen.
• Refer to the module instruction manual for
details of the settings.
NOTE: Insert or remove the CI module only
when the TV is in STAND-BY mode or
SWITCHED OFF.

Menu System

Picture Menu

Mode
For your viewing requirements, you can set
the related mode option.
Press or
or button to choose from one of these
options: Cinema, Dynamic and Natural.
Contrast/Brightness/Sharpness/Colour/
Hue
Press or
option. Press
Note: Hue option can only be visible when
the TV receives an NTSC signal.

Colour Temp

Press or
Press  /
options: Cool, Normal and Warm.
Note:
• Setting Cool option gives white colours a
slight blue stress.
• Setting Warm option gives white colours a
slight red stress.
• For normal colours, select Normal option.
English - 29 -
PICTURE
Mode
Contrast
Brightness
Sharpness
Colour
Colour Temp
Noise Reduction
Film Mode
Store
Reset
NO SIGNAL
button to select Mode. Press
button to select the desired
 /  button to set the level.
button to select Colour Temp.
 to choose from one of these
Dynamic
63
63
31
99
Normal
Low
Off