First Time Installation - Finlux 26FLHD846 Bedienungsanleitung

Use this setting to clear channels stored. Press " " or "
" button to select Clear Service List and then press OK.
The following OSD will be displayed on the screen:
Press OK to cancel. Select Yes by pressing " " or " "
button and press OK to delete all of the channels.

First Time Installation

The user can use this item to load default settings,
which were loaded to the receiver at the factory.
To install factory settings, highlight "First Time
Installation" menu item and press OK button, then
you will be asked whether or not to delete the settings.
Selecting "Yes" by pressing OK button will delete the
existing channel table.
After factory settings are loaded, "First Time
Installation" menu will be displayed.
The menu which is displayed for language selection
appears on the screen at fi rst. By using " " or "
" buttons, select the desired language option,
and press OK button to activate. After then, "First
time installation" OSD will appear on the screen.
By pressing " " or " " buttons, select the Country
you want to set and press OK button (* only for EU
countries). Next, active antenna mode selection OSD
will appear on the screen. Use " " or " " to set and
press OK to continue. See the section, "Initial Settings"
for more information. After active antenna mode option
is selected, a message asking for automatic search
appears on the screen:
Highlight "Yes" item by pressing " " or " " buttons
and press OK button to start installation. • To select
the "Yes" or "No" option, highlight the item by using "
" or " " buttons and press OK button.
After then, the following OSD will be displayed on
the screen:
If you select CABLE option, the following screen will
be displayed:
You can select frequency ranges from this screen. For
highlighting lines you see, use " " or " " button. You
can enter the frequency range manually by using the
numeric buttons on the remote control. Set Start and
Stop Frequency as desired by using numeric buttons
on the remote control. After this operation, you can set
Search Step as 8000 KHz or 1000 KHz. If you select
1000 KHz, the Tv will perform search process in a
detailed way. Searching duration will thus increase
accordingly. When fi nished, press OK button to start
automatic search. Automatic searching screen will be
displayed during the process.
Note: If you select an extended gap between Start
and Stop frequency rate, automatic search duration
will take a longer time.
If you select AERIAL option from the Search Type
screen, the digital television will search for digital
terrestrial TV broadcasts:
The IDTV will automatically tune to the UHF or VHF
(** for EU countries) transmission channels, searching
for digital terrestrial TV broadcasts and displaying the
names of channels found. This process will take about
a few minutes. To cancel searching, you can press the
"MENU" button at any time during the process.
Note: If the digital TV fails to store any channels, "No
channels available." message will be displayed on
the screen.
Either you select AERIAL or CABLE option from the
search type menu, after the digital automatic search
is completed, the following message asking for
analogue channel search appears on the screen:
Operation of analogue channel installation is explained
previously in "Initial Installation" section.
English - 60 -