Husqvarna SMR 511 2012 I.E. Bedienungsanleitung Seite 93

BRAKE PADS REMOVAL
REAR
- Remove clips (1).
- Slide out pin (2).
- Remove pads.
FRONT
- Press on clips (3).
- Slide out pins (4).
- Remove clips (3).
- Remove pads.
*:
WARNING
Do not work the brake lever or pedal
while removing the pads.
PADS WEAR
Check brake pad wear.
Service limit " A" is: 3.8 mm (0.15 in).
If service limit is exceeded, always replace the pads in pairs.
PADS CLEANING
Be careful that no brake fluid or any oil gets on brake
pads or discs. Clean off with alcohol any fluid or oil that
inadvertently gets on the pads or disc. Replace the pads
with new ones if they cannot be cleaned satisfactorily.
PADS INSTALLATION
REAR
- Install new brake pads.
- Reassemble the two pins (2) and the clips (1).
FRONT
- Install new brake pads.
- Install clips (3) by pushing them toward the calliper.
- Install the pins (4).
- Pull clips (3) out, to make sure they are engaged on
pins (4)
WARNING*:
Do not attempt to ride the motorcycle
until the brake lever or pedal are fully
effective. "Pump" with the brake lever
or pedal until the pads are against the
discs. The brake will not function on the
first application of the lever or pedal.
REAR
1
1
SPECIFICATIONS - OPERATION - MAINTENANCE
FRONT
3
3
2 FRONT
4
4
REAR
EN - 43