Husqvarna SMR 511 2012 I.E. Bedienungsanleitung Seite 86

ADJUSTING THE SHOCK ABSORBER SPRING PRELOAD
- Turn pin (1) counter clockwise and remove saddle
from central retaining screw;
1
- remove right-hand side panel (2) by loosening the
five screws (3) using an 8 mm wrench;
3
2
SPECIFICATIONS - OPERATION - MAINTENANCE
EN - 36
3
- Clean spring (6) lock ring nut (4), and adjuster ring
nut (5).
- Loosen lock ring nut using a hook wrench or an alu-
minium drift.
- Turn adjuster ring nut until reaching the desired position.
- After having adjusted the suspension based on your
weight and riding style, tighten lock ring nut (tighten-
ing torque 5 Nm; 0,5 Kgm; 3,69 ft-lb).
- Refit the right-hand side panel and the saddle.
WARNING*: Be careful not to touch hot
exhaust pipe while adjusting the shock
absorber.
4
5
6