Transport / Storage / Installation; Transport; Storage; Installation - Ranpak FillOak TT Bedienungsanleitung

FillPak TT with Cut Mechanism
®
1. TRANSPORT / STORAGE /
EN

INSTALLATION

1.1

Transport

The converter has been provided with swivel wheels to be
able to move it to various packing stations. These wheels
are suitable for travelling short distances on level, hard
industrial flooring:
• Switch the converter off
• Remove the power plug from the wall socket
• Collect any loose cords
• Unlock the wheels and move the converter to the
required location
• Once in position, lock the wheels using the built-in
brakes.
Be careful:
The converter weighs ± 34kg (75 lbs.)
The converter can be top-heavy.
Warning!
Ensure that the cords cannot be
damaged. Pay special attention to areas
where people work with vehicles (such
Warning!
as forklift trucks).
For transport over longer distances strap the converter
onto the enclosed pallet. Then the converter can be lifted
with a forklift truck.
1.2

Storage

• The storage room must be dry
• The converter must not be set up or stored in a place
where it is subject to moisture or water
• Before using the converter after a long storage period,
it must be inspected by a trained service technician
If the converter is taken from a cold to
a warm area, temporary condensation
can form on the converter (both
internally and externally). Turning the
converter on right away may damage
Warning!
the converter and create danger for the
operator. Let the converter reach room
temperature before turning it on.
1.3 Installation
1.3.1 Mechanical
Warning: the assembled converter in the
stand can be top-heavy. Be careful!
Warning!
Follow the assembly instructions supplied with the
converter.
The converter can be easily placed in the desired position.
Preferably the paper outlet should be placed above the
packing station.
1
1.3.2 Electrical
The electrical connection regulations are mentioned in
paragraph 2.2 "Electrical Connections". In addition, all
local connection regulations must be followed.
• Connect the foot switch.
• Insert the power plug into a grounding-type wall socket.
• Do not use cable reels. When using an extension
cable, note that the diameter must be at least 1,5 mm
(14AWG) with a maximum length of 10 m (33 ft.)
FillPak TT with Cut Mechanism Operator Manual - EN
®
2