Transport / Storage / Installation; Transport; Storage; Installation - Ranpak Geami WrapPak HV Betriebsanleitung

Geami WrapPak HV
1. TRANSPORT / STORAgE /
EN

INSTALLATION

1.1

Transport

• Switch the converter off
• Remove the power plug from the wall socket
• Collect any loose cords
• Move the converter to the required location
Be careful:
The converter weighs ± 31 kg (68 lbs.)
Warning!
Ensure
damaged. Pay special attention to areas
where people work with vehicles (such as
Warning!
forklift trucks).
For transport over longer distances strap the converter onto
the enclosed pallet. Then the converter can be lifted with a
forklift truck.
1.2

Storage

• The storage room must be dry
• The converter must not be set up or stored in a place
where it is subject to moisture or water
• Before using the converter after a long storage period, it
must be inspected by a trained service technician
If the converter is taken from a cold to a
warm area, temporary condensation can
form on the converter (both internally
and externally). Turning the converter on
right away may damage the converter and
Warning!
create danger for the operator. Let the
converter reach room temperature before
turning it on.
1.3 Installation
1.3.1 Mechanical
Warning: the assembled converter is
heavy. Be careful!
Warning!
The converter can be easily placed in the desired position.
The paper outlet should be placed above the packing station.
1
®
that the cords cannot
1.3.2 Electrical
The electrical connection regulations are mentioned in
paragraph 2.2 "Electrical Connections". In addition, all local
connection regulations must be followed.
• Connect the foot
• Plug the power cable in the
• Insert the power plug into the wall socket with ground
contact.
• Do not use cable reels. When using an extension cable,
note that the diameter must be at least 1,5 mm
with a maximum length of 10 m (33 ft.)
be
Geami WrapPak HV Operator Manual - EN
switch.
converter.
(14AWG)
2