Eds Operation Of Fillpak Tt With Cutter Conversion Unit Upgrade; Turning The Converter Off - Ranpak FillOak TT Bedienungsanleitung

FillPak TT with Cut Mechanism
®
3.5 EDS operation of FillPak TT with cutter
EN
conversion unit upgrade
[set the material to automatically produce a pre-set
length from 1 foot to 10 feet (0.305 m to 3.05 m)]
After completing all required actions as stipulated in
Sections 3.2 "Converter set up" and 3.3 "Loading the
paper", the PaperStar™ shaped material can be produced,
using the following steps:
1. Press the Electronic Delivery System (EDS) switch to
the "ON" or "I" position.
2. Set the paper length from 1 foot to 10 feet (0.305 m to
3.05 m) using the dial.
3. Press the foot switch to initiate paper feed.
4. Evaluate the paper to the desired length.
5. If longer / shorter paper length is needed, then readjust
the dial accordingly (clockwise to increase length,
counterclockwise to decrease length).
5
6. Remove the paper from the converter to feed the next
pre-determined PaperStar™ shaped material. No
operation of the foot switch is required.
7. To cancel EDS operation, press the EDS switch to the
"OFF" or "O" position.
8. To override EDS mode, press the foot switch while the
paper is being produced.
3.6

Turning the converter off

After use, the converter can be turned off by putting the
main switch to the "OFF" or "O" position.
Turning
Mechanism off at the power supply
without turning off the EDS switch will
Warning!
cause the unit to stay in EDS operation..
FillPak TT with Cut Mechanism Operator Manual - EN
®
the FillPak TT with Cut