Operator Instructions; Operator Control Panel; Converter Set Up - Ranpak FillOak TT Bedienungsanleitung

FillPak TT with Cut Mechanism
®

3. OPERATOR INSTRUCTIONS

EN
Before operating the converter, the
information from
be read and understood.
Warning!
3.1

Operator control panel

1.
2.
3.
4.
• Power lamp – see Section 5.3 for function
• Error lamp – see Section 5.3 for function
• Reset button – This button is used to acknowledge
operation error (red light)
3
Section "Safety" must
Main Supply to the
converter
Power Button
- Set the main switch to
"On"
Power/Main Switch
Indicator Light
- Converter is ready for
use
Fuse
Accessory Ports
includes:
- 2 Foot Switches
• EDS mode switch – see Section 3.5 for function
• EDS mode pad length control – see Section 3.5 for
function
3.2

Converter set up

Follow the assembly instructions supplied with the
converter and check that the following conditions are met:
• Section "Safety" of this manual has been read and
understood
• The electrical connection from the cutter head is
connected to the power supply
• The electrical connection from the feed motor is
connected to the cutter head
• The foot switch is plugged in
• All covers are secured
• Hands are free from the converter inlet/outlet
• The two safety pins on the stand are in place
Then follow these steps:
- Plug the power plug into the wall socket (if applicable)
- Set the main switch to "ON" or "I"
◦ A lamp will light up on the operator main switch
◦ The green lamp will light up on the cutter head
The converter is now ready for use.
FillPak TT with Cut Mechanism Operator Manual - EN
®