Herunterladen Inhalt Inhalt Diese Seite drucken

Transport / Storage / Installation; Transport; Storage; Installation - Ranpak PadPak PPLC2 Betriebsanleitung

Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 101
PadPak
LC
®
1. TRANSPORT / STORAGE /
EN

INSTALLATION

1.1

Transport

The converter has been provided with swivel wheels to be
able to move it to various packing stations. These wheels
are suitable for travelling short distances on level, hard
industrial flooring:
Switch the converter off
Remove the power plug from the wall socket
Collect any loose cords
Unlock the wheels and move the converter to the
required location
Once in position, lock the wheels using the built-in
brakes.
Be careful:
The converter weighs ± 103 kg (220 lbs.)
The converter can be top-heavy.
Warning!
Ensure that the cords cannot be
damaged. Pay special attention to areas
where people work with vehicles (such
Warning!
as forklift trucks).
For transport over longer distances strap the converter
onto the enclosed pallet. Then the converter can be lifted
with a forklift truck.
1.2

Storage

The storage room must be dry
The converter must not be set up or stored in a place
where it is subject to moisture or water
Before using the converter after a long storage period,
it must be inspected by a trained service technician
If the converter is taken from a cold to
a warm area, temporary condensation
can form on the converter (both
internally and externally). Turning the
converter on right away may damage
Warning!
the converter and create danger for the
operator. Let the converter reach room
temperature before turning it on.
1
1.3
Installation
1.3.1 Mechanical
Warning: the assembled converter in
the stand can be top-heavy. Be careful!
Warning!
The converter can be easily adjusted to allow the paper
chute to be positioned above the packing area.
Adjust height:
Remove the 4 bolts of
the under carriage;
Move the converter up
or down
Fasten the bolts again
and tighten them.
Adjust angle:
Turn
the
handle
counterclockwise;
Adjust the angle of the
converter
Tighten the handle.
1.3.2 Electrical
The electrical connection regulations are mentioned in
paragraph 2.2 "Electrical Connections". In addition, all
local connection regulations must be followed.
Connect the foot switch and the remote control.
Test the functioning of the Emergency Stop button
Insert the power plug into a grounding-type wall socket.
Do not use cable reels. When using an extension
cable, note that the diameter must be at least 1,5 mm
(14AWG) with a maximum length of 10 m (33 ft.)
PadPak PPLC2 Operator Manual - EN
2

Quicklinks ausblenden:

Werbung

Inhaltsverzeichnis

Fehlerbehebung

loading

Diese Anleitung auch für:

Padpak lc

Inhaltsverzeichnis