Honda BF50D Bedienungsanleitung Seite 802

16. IAT (INTAKE AIR TEMPERATURE)
SENSOR
• REPLACEMENT
1) Remove the engine cover (P. 4-2).
2) Disconnect the IAT sensor 2P connector.
3) Remove the IAT sensor.
4) Install the new IAT sensor.
5) Connect the IAT sensor 2P connector.
6) Install the engine cover (P. 4-2).
17. MAP (MANIFOLD ABSOLUTE
PRESSURE) SENSOR
• REPLACEMENT
1) Remove the engine cover (P. 4-2).
2) Remove the breather tube from the fuel tube clamp B.
3) Disconnect the MAP sensor 3P connector.
4) Remove the MAP sensor screw and remove the MAP
sensor and the O-ring.
5) Apply engine oil to the new O-ring and install it on the new
MAP sensor.
6) Install the new MAP sensor and tighten the MAP sensor
screw to the specified torque.
TORQUE: 3.5 N . m (0.4 kgf . m, 2.6 lbf . ft)
7) Connect the MAP sensor 3P connector.
8) Install the fuel tube clamp B between the protection tubes
on the breather tube.
9) Install the engine cover (P. 4-2).
5-117
[1]
IAT SENSOR
[2]
IAT SENSOR 2P CONNECTOR
[2]
MAP SENSOR
[1]
O-RING
[7]
PROTECTION
TUBES
802
[3]
MAP SENSOR
SCREW
[4]
MAP SENSOR 3P
CONNECTOR
[6] [5]
FUEL TUBE BREATHER
CLAMP B TUBE