Honda BF50D Bedienungsanleitung Seite 280

[1]
CLAMPS
1
Set the main wire harness
in the clamp securely.
2
3
4
5
6
7
8
9
10
[6]
CLAMPS
11
Set the alternator stator wire and
trim angle sensor wire [Power
12 trim/tilt type only] in the clamp
securely with the alternator stator
wire on the inner side (engine
13
side).
14
[5]
ROUND PROJECTION
15
Route the alternator stator
wire from the left side along
16 the circumference of the
round projection.
17
18
19
20
[7]
PROJECTION
2-66
[1]
CLAMPS
Set the main wire harness
in the clamp securely.
[7]
PROJECTION
[4]
CLAMP
Set the HO2S wire in
the clamp securely.
GND2
[8]
MAIN WIRE HARNESS
GROUND CABLE
Install while pushing the
ground cable against the
projection on the cylinder
block.
GND1
[8]
MAIN WIRE HARNESS
GROUND CABLE
Install while pushing the
ground cable against the
projection on the cylinder
block.
280
[2]
CLAMPS
Set the pulser coil wire
in the clamp securely.
[3]
CLAMPS
Set the main wire harness
ground cable in the clamp
securely.