Omron VS mini J7 Kurzanleitung Seite 17

2. Control Circuit Terminals
Symbol Name
Input S1 Forward/Stop
S2 Multi-function Input 1
S3 Multi-function Input 2
S4 Multi-function Input 3
S5 Multi-function Input 4
SC Sequence Input Common
FS Frequency Reference Power Supply DC power supply for frequency reference use
FR Frequency Reference Input
FC Frequency Reference Common
Output MA Multi-function output: NO
MB Multi-function output: NC
MC Multi-function output Common
AM Analogue Monitor output
AC Analogue Monitor output Common
*1 NPN is the setting for these terminals. No external power supply is required. Refer to connections shown below
*2 Functions in parentheses are default settings.
Selecting Input Method
Switches SW7and SW8, both of
which are located above the cont-
rol circuit terminals, are used for in-
put method selection.
Remove the front cover and optio-
nal cover to use these switches.
Selecting Sequence Input Method
By using SW7, NPN or PNP input can be selected as shown below
NPN
(Default setting) GND
S1 to 5
SC
24V
SW7
0.1µ
360
3.3k
GND
Function
Forward at ON/Stops at OFF
Set by parameter n36 (Reverse/Stop)
Set by parameter n37 (External Fault: NO)
Set by parameter n38 (Fault Reset)
Set by parameter n39
*2
(Multi-step reference 1)
Common for S1 through S5
Input terminal for frequency reference use
Common for frequency reference use
Set by parameter n40 (during running)
Common for MA and MB use
Set by parameter n44 (Output frequency)
Common for AM use
SW7
PNP SW8
V
NPN
SW7
PNP
24 V DC
(±10%)
Photocoupler 8 mA
*2
at 24 V DC
*2
*2
20 mA at 12 V DC
0 to 10 V DC (20 kΩ)
4 to 20 mA
0 to 20 mA
*2
Relay output 1 A
max. at 30 V DC and
250 V AC
*2
12 mA max. at 0 to
10 V DC
I
SW8
SW7
GND
0.1µ
S1 to 5
360
3.3k
SC
GND
Signal Level
*1
Control circuit
terminal block
Control circuit
terminal block
24V