Hilti PS 200 S Bedienungsanleitung Seite 45

Switch the scanner on and use the arrow buttons to
select the Blockscan symbol from the main menu. The
battery state of charge is indicated, together with the
number of Imagescans currently held in the memory out
of a maximum of 9.
A representation of a Blockscan is shown on the screen.
Each square represents an Imagescan. Up to 3 x 3
Imagescans can be made. Select the position of the
first Imagescan that you will make in the series using
the arrow buttons. Press Confirm to begin the first
Imagescan. Note that the coordinates of any points
on the Blockscan will be referenced from the upper left
corner.
For details of how to make an Imagescan, please refer
to 6.13. When the Imagescan is complete, the system
returns to the Blockscan screen.
The completed Imagescan is shown shaded.
Select the next Imagescan position and repeat the scanning procedure. Imagescans already made may be
repeated simply by reselecting the area to scan and carrying out the Imagescan again. The data will be
overwritten. Once all the Imagescans have been recorded, or the maximum number of scans that can be
held in memory is reached (9), press the Cancel button to return to the main menu. For visualization and
analysis, the data is transferred to the tablet.
Note
Pressing the Cancel button twice causes the recorded Imagescan to be deleted. The screen then
returns to the main menu.
Printed: 14.11.2016 | Doc-Nr: PUB / 5314765 / 000 / 00
English 41