Renson LAPURE Gebrauchsanleitung Seite 84

Setting Fixscreen
A. Select the desired channel on the
TELIS 4- or 16-channel remote for the
Fixscreen.
B. Press the remote's UP and DOWN
button simultaneously (briefly). The
Fixscreen makes short movement
upwards and downwards.
C. Check if, when pressing the UP
button on the remote, the Fixscreen
makes an upward movement. And
check that, when pressing the DOWN
button on the remote, the Fixscreen
makes a downward movement. If so,
you can proceed to step E.
D. If the result of your check in step C
is not correct, press for more than
5 seconds on the MY button on the
remote until the Fixscreen makes a
short up- and downward movement.
Check that step C is now giving
correct results.
84
end points (with RTS control)
®
E. Press the UP button on the remote
i until you have reached the desired
upper end point.
F. Press the MY and the DOWN buttons
on the remote simultaneously (briefly)
to confirm this upper end point.
G. The Fixscreen goes automatically
down Press (shortly) on the MY button
of the remote as soon as you have
reached the desired bottom lower
end point.
Note: You can still make some
adjustments by pressing the UP or
DOWN button.
Take the lower end point the first time
5 mm from the bottom, because the
fabric is still stretching. Check this
end point after a while and change if
necessary.
H. Press (shortly) the MY and the DOWN
buttons on the remote simultaneously
(shortly) to confirm
end point. The Fixscreen
automatically back up.
I. Press briefly on the MY button to stop
the Fixscreen movement at any point.
J. Press for more than 2 sec. on the MY
button until the Fixscreen makes a
short up- and downward movement.
K. Press briefly on the PROG button
on the rear of the TELIS remote. The
Fixscreen makes short an up- and
downward movement. By doing this
all settings are stored. Then check the
end points again.
this bottom
goes