Safety Measures - Vitek VT-4206 R Betriebsanweisung

ENGLISH
MULTICOOKER
The multicooker is intended for cooking and warming
of food.
Description
1. Multicooker body
2. Lid opening button
3. Bowl
4. Protection screen clamps
5. Protection screen
6. Multicooker lid
7. Carrying handle
8. Power cord connector
9. Display
10. Control panel
11. Steam valve
12. Steam release opening
13. Heating element
14. Temperature sensor
15. Soup ladle
16. Measuring cup
17. Spatula
18. Power cord
19. Steam cooking basket
Control panel
20. "STOP/Keep warm" button
21. "RICE" button
22. "DELAYED START" button
23. "HOURS" button
24. "MINUTES" button
25. "TIMER" button
26. "MENU" button
27. "START" button
28. Additional accessories: Yogurt cups
Attention!
For additional protection it is reasonable to install a
residual current device (RCD) with nominal operation
current not exceeding 30 mA. To install the RCD contact
a specialist.

SAFETY MEASURES

Before using the multicooker, read this instruction
manual carefully and keep it for future reference.
• Use the multicooker for intended purpose only, as it
is stated in this instruction manual. Mishandling the
unit can lead to its breakage and cause harm to the
user or damage to his/her property.
• Before using the unit, examine the power cord and
the power cord connector located on the unit body
closely and make sure that they are not damaged.
Never use the unit if the power cord, plug or power
cord jack is damaged.
VT-4206.indd 4
• Before switching the unit on make sure that voltage
of the mains corresponds to unit operating voltage.
• Power cord is equipped with "euro plug"; plug it into
the socket with reliable grounding contact.
• Do not use adapters for plugging the unit in.
• Make sure that the power cord is properly inserted
into the corresponding connector of the multi-
cooker and power plug - in the socket.
• Use only the supplied power cord, do not use a
power cord of other units.
• Use only the removable parts supplied with the unit.
• Place the unit on a flat heat-resistant surface away
from sources of moisture, heat and open flame.
• Place the unit with free access to the mains socket.
• Use the unit in places with proper ventilation.
• Do not expose the unit to direct sunlight.
• Do not place the unit close to walls and furniture.
• Free space above the multicooker should be at least
30-40 cm.
• Avoid contact of the power cord with hot and sharp
subjects. Avoid damaging the isolation of the power
cord.
• Do not touch the multicooker body, power cord or
power plug with wet hands.
• Do not immerse the unit, the power cord and power
plug into water or any other liquids.
• If the unit was dropped into water, unplug it imme-
diately, and only then take it out of water. Apply to
the authorized service center for the further use
of the unit.
• Do not insert foreign objects into steam release
openings, and make sure that foreign objects do
not get between the lid and body of the multicooker.
• Do not leave the unit unattended. Always unplug the
unit when you are not using it.
• To avoid burns do not bend over the steam release
opening and open the lid. Be very careful when
opening the multicooker lid during and immediately
after cooking. Danger of burns by hot steam!
• When the multicooker is operating in "Roasting"
mode, do not bend over the unit to avoid burns by
splattering hot oil.
• Do not use the unit without installed bowl and also
without liquid and/or products in the bowl.
• Follow all the recommendations for amount of dry
products and liquids.
• Do not remove the bowl during operation.
• Do not cover the unit during operation.
• Do not carry the unit during operation. Use the car-
rying handle, unplug the unit and let it cool down
preliminary.
• The body and inner parts of the unit heat up during
the operation. Do not touch them with open body
parts or bare hands, if you need to take the hot bowl
out, use thermal protective potholders.
4
30.05.2013 15:26:05