Werbung
Verfügbare Sprachen
Verfügbare Sprachen
CUTTING BOARD
(GRSSR SERIES ONLY)
The cutting board comes equipped with rubber feet on bottom
to fit right on top of base.
The cutting board is made of the same material as Swanstone
base and is available in the same colors as the base. The
available colors include, Gray, Granite, Bermuda Sand, Night
Sky and Sawgrass.
REMOTE MOUNTED CONTROL PANEL
(SEE 13 & 14 )
WARNING
For proper and safe operation the remote control panel
location must be mounted on a vertical wall and installed
in the vertical position.
NOTICE
The remote mounted control panel should be installed
outside of the heat zone. Locating the control panel inside
the heat zone will cause the control(s) to overheat,
malfunction, and fail. See Figure
mounting distances.
NOTE: A qualified electrician is recommended for connecting
the units to a power source.
1. Remove trim cover from control panel assembly.
2. Position control panel into opening through the backside.
3. Secure
control
panel
(not supplied).
4. Connect proper power source to the mounted remote
control panel.
5. Reinstall trim cover.
NOTE: Units are equipped with a 914 mm (36") flexible conduit
connected to the control panel.
CAUTION
Some exterior surfaces on the unit will get hot. Use
caution when touching these areas to avoid injury.
CAUTION
Unit is not weatherproof. For safe and proper operation
the unit must be located indoors where the ambient air
temperature is a minimum of 21°C (70°F) and a maximum
of 29°C (85°F).
9
for maximum
to
surface
using
screws
POWER ON/OFF
Place the On/Off switch in the "ON" position. The indicator light
glows when the unit is on. (See 13 )
TEMPERATURE CONTROL
(FLUSH MOUNT CONTROL BOX WITH
®
THERMOSTAT)
Turn thermostat control knob to adjust the temperature of the
Built-In unit to the desired safe food temperature.
PROGRAMMING FLUSH MOUNT CONTROL
BOX WITH INDICATING TEMPERATURE
CONTROL (ITC) (SEE 15 )
GRSSB series unit must not have a temperature setpoint
higher than 93°C (200°F). Temperatures exceeding 93°C
(200°F) will damage the unit and void the warranty.
NOTE: On start-up, when the unit is at ambient room
temperature, the displayed temperature reading may be
inaccurate when temperature is below 54°C (130°F).
If programming sequence is interrupted before completing the
last step, the changed values will not be accepted into memory.
After ten seconds of inactivity during the programming process,
controller will automatically exit programming mode and revert
back to the original temperature value without accepting the
new value.
Setting the Temperature Setpoint
1. Press the SET button once to display temperature setpoint,
(SP).
2. Press the SET button again to display the current setpoint
value.
3. Press the UP or DOWN arrow button to select the desired
setpoint value. Pressing and holding either of the arrow
buttons will advance the setpoint change rapidly.
4. Press the SET button to complete the programming
sequence and enter the value into memory.
NOTE: Display will go blank for two seconds to acknowledge
the end of the programming sequence and acceptance of the
new temperature value.
13
ACCESSORIES
NOTICE
Form No. GRSSCEM-1207
Werbung
Kapitel
Fehlerbehebung
