Important Safety Information - Hatco GLO-RAY GRSS Serie Installations- Und Bedienungshandbuch

IMPORTANT SAFETY INFORMATION

IMPORTANT! Read the following important safety information to avoid personal injury or death, and to
avoid damage to the equipment or property.
WARNINGS
To avoid any injury or damage to the unit turn the
power switch OFF, unplug the unit and allow to cool
before performing any maintenance or cleaning.
The Glo-Ray Heated Stone Shelf is not waterproof. To
avoid any injury or damage to the unit DO NOT
submerge or saturate with water. Do not operate if it
has been submerged or saturated with water.
For safe and proper operation plug unit into a properly
grounded electrical outlet of the correct voltage, size
and plug configuration. If the plug and receptacle do
not match, contact a qualified electrician to determine
the proper voltage and size and install the proper
outlet.
To avoid any injury or damage to the unit do not pull
unit by power cord.
To prevent any injury, discontinue use if power cord is
frayed or worn.
Do not lay unit on the side with the control panel or
damage to the unit could occur.
For safe and proper operation, the unit must be
located a reasonable distance from combustible walls
and materials. If safe distances are not maintained,
discoloration or combustion could occur.
To avoid any injury or damage, the Heated Stone Shelf
must only be serviced by qualified personnel.
If the power supply cord is damaged, it must be
replaced by Hatco, an Authorized Service Agent, or a
person with similar qualifications to avoid a hazard.
This appliance is not jet-proof construction. To assure
safe and proper operation do not use jet-clean-spray
to clean this appliance.
For proper and safe operation the remote control panel
location must be mounted on a vertical wall.
If service is required on this unit, contact your
Authorized Hatco Service Agent, or contact the Hatco
Service Department at 414-671-6350; International fax
414-671-3976.
This product has no "user" serviceable parts. To avoid
damage to the unit or injury to personnel, use only
Authorized Hatco Service Agents and Genuine Hatco
Replacement Parts when service is required.
Genuine Hatco Replacement Parts are specified to
operate safely in the environments in which they are
used. Some aftermarket or generic replacement parts
do not have the characteristics that will allow them to
operate safely in Hatco equipment. It is essential to
use Hatco Replacement Parts when repairing Hatco
equipment. Failure to use Hatco Replacement Parts
may subject operators of the equipment to hazardous
electrical voltage, resulting in electrical shock or burn.
Form No. GRSSCEM-1207
Unit is not weatherproof. For safe and proper operation
locate the unit indoors where the ambient air
temperature is a minimum of 21°C (70°F).
To avoid any injury or damage locate the unit at the
proper counter height, in an area that is convenient for
use. The location should be level to prevent the shelf
or its contents from accidentally falling, and strong
enough to support the weight of the unit and food.
Some exterior surfaces on the unit will get hot. Use
caution when touching these areas to avoid injury.
To avoid any injury or damage do not operate the
GRSSB (Built-In Models) without the trim mounting
ring and the control box properly mounted per the
installation instructions.
Damage to non-metallic countertop material caused by
heat generated from Hatco equipment is not covered
under the Hatco warranty. Recommended for use in
metallic counters. For other surfaces, verify that the
material is suitable for temperature up to 93°C (200°F).
GRSSB series unit must not have a temperature
setpoint higher than 93°C (200°F). Temperatures
exceeding 93°C (200°F) will damage the unit and void
the warranty.
The remote mounted control panel should be installed
outside of the heat zone. Locating the control panel
inside the heat zone will cause the control(s) to
overheat, malfunction, and fail. See Figure 9 for
maximum mounting distances.
6
CAUTIONS
NOTICES