Display Light Bulb Replacement; Accessories - Hatco FDW Serie Installations- Und Bedienungshandbuch

DISPLAY LIGHT BULB REPLACEMENT

The display light is an incandescent bulb which illuminates
the warming area. This bulb has a special coating to guard against
injury and food contamination in the event of breakage.
To replace a bulb, disconnect the power supply and wait until
the unit has cooled. Display lamps have a threaded base. Unscrew
the bulb from the unit and replace it with a new specially coated
incandescent bulb. Hatco shatter-resistant bulbs meet N.S.F.
Standards for food holding and display areas.
Only light bulbs which meet or exceed N.S.F. Standards,
specifically designed for food holding areas must be used.
Breakage of light bulbs not specially coated could result
in personal injury and/or food contamination.
If service is required on this unit, contact your Authorized
Hatco Service Agent, or contact the Hatco Service Department
at 800-558-0607 or 414-671-6350; fax 800-690-2966
or international fax 414-671-3976.

ACCESSORIES

10 CM (4") ADJUSTABLE LEGS
To install the 10 cm (4") appliance legs, place the unit on its side.
Be sure to secure all glass with tape. Remove the four (4) 2.5 cm
(1") metal screw type feet. Screw the 10 cm (4") legs into the holes
provided. After all the legs are tightened, return the unit to its
upright position. If the unit is not level or rocks, turn the adjustable
tip of the appropriate leg to correct the condition. See 8 .
FRENCH DOORS
Attractive French doors are available on all Flav-R-Fresh models.
When used on models FDW-1 or FDW-2, only one door controls
the rack pause switch.
DISPLAY RACKS
A chrome-plated 4-tier circle rack, a chrome-plated
4-shelf multi-purpose rack and a stainless steel pretzel tree
are available to "customize" Flav-R-Fresh to your foodservice
operation. See 9 .
Downloaded from www.Manualslib.com
WARNING
WARNING
manuals search engine
WARNING
This product has no "user" serviceable parts. To avoid damage
to the unit or injury to personnel, use only Authorized Hatco
Service Agents and Genuine Hatco Parts when service
is required.
WARNING
Genuine Hatco Replacement Parts are specified to operate
safely in the environments in which they are used. Some
aftermarket or generic replacement parts do not have
the characteristics that will allow them to operate safely
in Hatco equipment. It is essential to use Hatco Replacement
Parts when repairing Hatco equipment. Failure to use Hatco
Replacement Parts may subject operators of the equipment
to hazardous electrical voltage, resulting in electrical
shock or burn.
MERCHANDISING DECAL SIGNS/GRAPHICS
Self-adhesive merchandising decal signs and graphics are available
to promote your food products. The signs are designed
to be installed on three (3) sides of the cabinet above the glass
panels. Merchandising decal signs are red with yellow letters
reading PIZZA or PRETZELS. Graphic decals feature food
illustrations only and are available for Pizza, Chicken, Pretzels
and Biscuits/Croissants.
Before installing decals, clean the stainless steel side panels with
a non-oily cleaner, such as isopropyl alcohol (rubbing alcohol).
After the cleaned surfaces have dried, simply remove the protective
backing from the sign or decal and apply to the panel. Any air
pockets or bubbles behind the sticker can be removed by rubbing
gently with a soft cloth from the center towards the outer edges.
10
MAINTENANCE
Form No. FDWCEM-1002