Installation; Transport And Storage; Unpacking; Installation Requirements - Grundfos Conex DIS-C Montage- Und Betriebsanleitung

8. Installation

8.1 Transport and storage

• Transport the device carefully, do not drop!
• Store at dry and cool location between -20 °C
and +65 °C.

8.2 Unpacking

Caution Do not allow any foreign bodies to enter!
• Check the device for damage. Install as soon as
possible after unpacking.
• Do not install or connect damaged devices!
Retain the packing material or dispose of it
Note
according to local regulations.
Installation of Conex
Fig. 6
1. Drill three dowel holes with a diameter of 8 mm.
See section
7.4 Dimensional sketches / drilling
diagram.
2. Insert the supplied dowel pins.
3. Unscrew the clamp cover from the device.
4. Screw in the top middle screw.
5. Hang the device onto this screw.
6. Secure the device using the other two screws.
7. Screw the clamp cover back on.
Do not damage the gasket.
Caution
The gasket must be fitted exactly.
10

8.3 Installation requirements

•
•
8.4 Assembling the Conex
®
DIS-C for wall mounting
If you do not observe the installation
requirements, the device may be
Caution
damaged! The measurements may not be
correct!
The location must be vibration-free, dry, dust-free
and free of corrosive, pungent fumes or
aggressive solvents.
Observe the data in section

for wall mounting

Warning
Switch off the power supply before
installing!
Enclosure class IP65 is only guaranteed if
the clamp covers and the associated
threaded cable connections and temporary
covers are closed.
151
7. Technical data.
®
DIS-C housing
120