Operating Mode A: Cleansing Using The Cleansing Surface - Silvercrest SGRS 3.7 A1 Bedienungsanleitung Und Serviceinformationen

SilverCrest SGRS 3.7 A1
10.2. Operating mode A: Cleansing
using the cleansing surface
1. Wash your face and fully remove any make-up.
2. Apply a small amount of your normal cleanser to your
forehead and cheeks.
3. Moisten the cleansing surface (1) with a little water.
4. Start the cleansing cycle by pressing the On/Standby
(4) button.
5. Cleanse your cheeks using gentle upward movements,
along your jaw from your chin and towards your ear.
6. Cleanse your forehead. Start in the middle and move
the face cleansing brush (A) outwards in the direction of
the arrow.
7. Now cleanse one side of your nose with gentle
movements up and down. Repeat this on the other side of
your nose.
8. The areas beneath the eyes are very sensitive. We
therefore recommend reducing the intensity of the
vibration before you start. Move the face cleansing brush
(A) outwards, starting from the nose.
9. End the cleansing mode by pressing the On/Standby
button (4).
10. Wash your face and remove any remaining cleanser
used.
11. Now dry your face thoroughly to prepare for the
massage phase.
12. Remove any remaining cleanser from the cleansing
area (1) by rinsing it under running water. Then dry off
the face cleansing brush (A).
96 - English