Setup; Assembling And Unfolding The Handle - Toro Recycler 20954 Bedienungsanleitung

Setup

Important:
Remove and discard the protective
plastic sheet that covers the engine and any other
plastic or wrapping on the machine.
1
Assembling and Unfolding
the Handle
No Parts Required
Procedure
1. Remove and save the 2 handle knobs and 2
carriage bolts from the handle brackets
3).
1. Handle knob (2)
2. Install the handle ends onto the mower housing
so that the pin attached to each handle bracket
is in the lower hole of its related handle end
(Figure 4).
All manuals and user guides at all-guides.com
(Figure
Figure 3
2. Carriage bolt (2)
1. Pin
Note:
The pins do not show through the holes
in the handle ends when the handle is in the
folded position.
3. Unfold the handle to the operating position by
rotating it rearward
g189864
1. Operating position
4. Insert the carriage bolt (with the bolt head toward
the inside) through the upper or lower square
hole in handle bracket and the upper hole in the
handle end
4
Figure 4
2. Handle end
(Figure 5).
Figure 5
2. Folded position
(Figure 6).
g189866
g192009