Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Risk of damage of the product
Only use the specified type of
battery / rechargeable battery!
Insert batteries / rechargeable
batteries according to polarity
marks (+) and (-) on the battery /
rechargeable battery and the
product.
Clean the contacts on the battery /
rechargeable battery and in the
battery compartment before in-
serting!
Remove exhausted batteries /
rechargeable batteries from the
product immediately.
Installation
Note: A cross-head screwdriver is required to
assemble the product.
Remove the product and the accessories from
the packaging.
Assemble the base parts
cross.
Screw the pole
13
mounting plate. Use the four included cross-head
screws
for this purpose.
16
Remove the height adjustment ring
ing it anticlockwise.
Push the cap
over the pole
14
the height adjustment ring
.
13
Pull the internal pole
. Secure the internal pole
13
the height adjustment ring
rotation.
Remove the fastening screw
anticlockwise.
10 GB/IE/NI
in the shape of a
15
to the bases
using the
15
by rotat-
12
. Then, place
13
back on the pole
12
out of the external pole
11
, by tightening
11
through clockwise
12
by turning it
10
Push the motor
on the internal pole
9
attach it using the fastening screw
screw clockwise to tighten.
Place the rear grill
on the motor
6
in Fig. D. Please ensure that the handle on the
rear grill
is located at the top.
6
Attach the rear grill
6
nut
. Turn the screw clockwise to tighten.
5
Push the blades
on the shaft
4
the smooth side of the shaft
Push the blade cover
3
screw it on anticlockwise to tighten it.
Hang the front grill
on the rear grill
1
using the hook
. Connect both grills using
2
the included screw
and nut.
18
Afterwards, close the fastening clamps.
Before first use
Place the product on a flat and stable surface
and ensure that there is a minimum of 10 cm of
clear space around the product. This product is
not suitable for connection or use in a cupboard
or outdoors.
Connect the mains cable to the socket.
Note: Before connecting the product, ensure
that the main voltage specified on the product
matches the local line voltage (Voltage:
220–240 V ∼).
Inserting / changing the battery
Open the battery compartment on the back of
the remote control.
Insert the batteries or replace the old batteries
with new ones. Only use batteries of the speci-
fied type („Technical data").
Note: When inserting the batteries, please
observe the correct polarity. This is indicated in
the battery compartment.
Close the battery compartment.
and
11
. Turn the
10
as shown
9
using the rear grill lock-
. Ensure that
7
is facing down.
7
on the shaft
and
7
6
Quicklinks ausblenden:
Werbung
Kapitel
Inhaltsverzeichnis
