Stopping The Motor; Adjusting The Height-Of-Cut; Bagging The Clippings - Toro Eurocycler 21080 Bedienungsanleitung

4. While holding in the button, pull the control bar
toward the handle (Figure 16).
Figure 16
5. Hold the control bar to the handle and release the
button (Figure 17).
Figure 17

Stopping the Motor

1. Release the control bar (Figure 18).
Figure 18
2. Disconnect the mower from the power source if
you leave the mower unattended.

Adjusting the Height-of-Cut

The mower has 6 height-of-cut positions (all heights
are approximate): A=20 mm; B=31 mm; C=42 mm;
D=53 mm; E=64 mm; and F=75 mm.
Adjusting the cutting height levers could
bring your hands and feet into contact with a
moving blade and result in serious injury.
Stop the motor and wait for all moving parts to
stop before changing the height-of-cut setting.
1. Stop the motor and wait for all moving parts to
stop.
2. Press down on the height-of-cut adjustment button
with your thumb and push down or lift up the
height-of-cut handle to the desired cutting height
setting shown on the height-of-cut level reading
(Figure 19).
1. Height-of-cut adjustment
button
3. Release the height-of-cut adjustment button.

Bagging the Clippings

Install the grass box to collect the clippings.
1. Lift up the rear door and install the grass box on
the mower (Figure 20).
2. Release the rear door.
3. Move the recycling/bagging lever to bagging mode
(Figure 21).
7
Figure 19
2. Height-of-cut level
reading
Figure 20