Stopping The Engine; Recycling The Clippings; Bagging The Clippings - Toro Multicycler 20637 Bedienungsanleitung

Stopping the Engine

1. Release the blade control bar (Figure 17).
Figure 17
2. When the engine stops, remove the ignition key
when you leave the mower.
Important: When you release the blade control
bar, both the engine and blade should stop
within 3 seconds. If they do not stop properly,
stop using your mower immediately and contact
an Authorized Service Dealer.

Recycling the Clippings

Your mower comes from the factory ready to recycle the
grass and leaf clippings back into the lawn.
Note: The grass bag may remain on the mower while
you are recycling the clippings.
To recycle the clippings, move the Recycling/bagging
lever to the recycling mode (Figure 18).
Figure 18
1. Recycling mode

Bagging the Clippings

Use the grass bag when you want to collect grass and
leaf clippings from the lawn.
2. Bagging mode
A worn grass bag could allow small stones
and other similar debris to be thrown in the
operator's or bystander's direction and result in
serious personal injury or death to the operator
or bystanders.
Check the grass bag frequently. If it is
damaged, install a new Toro replacement bag.
The blade is sharp; contacting the blade can
result in serious personal injury.
Stop the engine and wait for all moving parts to
stop before leaving the operating position.
To bag the grass clippings, install the grass bag
(refer to Installing the Grass Bag) and move the
Recycling/bagging lever to the bagging mode
(Figure 18).
Installing the Grass Bag
Raise and hold up the rear door, install the bag, and
lower the rear door (Figure 19).
9
Figure 19