Using The Self-Propel Drive; Recycling The Clippings; Stopping The Engine; Bagging The Clippings - Toro Emotion Bedienungsanleitung

Using the Self-propel Drive

To operate the self-propel drive, simply walk with your
hands on the upper handle and your elbows at your
sides, and the mower will automatically keep pace with
you (Figure 17).

Stopping the Engine

1. Release the blade control bar (Figure 18).
2. When the engine stops, remove the ignition key
when you leave the mower.
Important: When you release the blade control
bar, both the engine and blade should stop
within 3 seconds. If they do not stop properly,
stop using your mower immediately and contact
an Authorized Service Dealer.
Figure 17
Figure 18

Recycling the Clippings

Your mower comes from the factory ready to recycle the
grass and leaf clippings back into the lawn.
Note: The grass bag may remain on the mower while
you are recycling the clippings.
1. Stop the engine and wait for all moving parts to stop.
2. Press the button on top of the Recycling/bagging
lever and move the lever to the recycling mode
(Figure 19).
1. Recycling mode

Bagging the Clippings

Use the grass bag when you want to collect grass and
leaf clippings from the lawn.
WARNING
A worn grass bag could allow small stones and
other similar debris to be thrown in the operator's or
bystander's direction and result in serious personal
injury or death to the operator or bystanders.
Check the grass bag frequently. If it is damaged,
install a new Toro replacement bag.
WARNING
The blade is sharp; contacting the blade can result
in serious personal injury.
Stop the engine and wait for all moving parts to stop
before leaving the operating position.
1. Stop the engine and wait for all moving parts to stop.
2. To bag the grass clippings, install the grass bag (refer
to Installing the Grass Bag). Press the button on top
of the Recycling/bagging lever and move the lever
to the bagging mode (Figure 19).
11
Figure 19
2. Bagging mode