Operation; Securing The Extension Cord; Planning Your Mowing Pattern; Starting The Motor - Toro Eurocycler 21080 Bedienungsanleitung

Operation

Securing the Extension Cord

Note: This procedure is for mowers that require an
extension cord.
Use only an extension cord recommended for outdoor
use.
Contacting water while operating the mower
could cause an electric shock, which can
cause an injury or death.
• Don't handle the plug or the mower with
wet hands or while standing in water.
• Use only an extension cord recommended
for outdoor cold weather use.
1. Form a loop in the extension cord and secure it in
the cord lock (Figure 12).
Figure 12
2. Connect the extension cord to the mower plug
(Figure 13).
Figure 13
Note: Do not unplug the extension cord by
pulling on the cord; to unplug the cord, grasp the
plug, not the cord.
The electrical cord could be damaged,
causing a shock or fire.
Thoroughly inspect the electrical cord before
using the mower. If the cord is damaged, do
not operate the mower. Have an Authorized
Toro Service Dealer replace or repair a
damaged cord immediately.
Planning Your Mowing
Pattern
Following the suggested mowing pattern will reduce
the risk of running over the cord with the mower, and
the cord will not sustain unnecessary wear. Do not
allow the power cord to wrap around trees, shrubs, or
other obstacles.
Begin by mowing near the electrical power source.
Mow back and forth, gradually mowing away from the
power source (Figure 14).

Starting the Motor

1. Connect the extension cord to the mower (if
applicable).
2. Plug the other end of the cord into a household
electrical power outlet.
3. Push the button on the left side of the handle and
hold it in (Figure 15).
6
Figure 14
Figure 15