Jacuzzi sasha series Bedienung Und Wartung Seite 49

Note regarding operation
of the hammam and the
scale-removal cycle
A "steam cycle" is understood
to mean the activation of one
of the available programs
preliminary operations
programme
activation
Activating the hammam depends on how many times the various different pro-
grams have been run already. If it is between 40 and 60 times, when pressing the
button for one of the programs, the water-pitcher symbol on the display flashes (a
blue light) for a few seconds. This means that a scale-removal cycle should be run
(but the hammam function can still be used).
However, when the maximum number of steam cycles (60) has been reached,
the function is no longer available (the water-pitcher symbol flashes white). You must
run a scale-removal cycle.
As an exception, the scale-removal cycle can be delayed and the hammam
function can continue to be used a certain number of times.
Always refer to the "Scale-removal cycle" section.
If desired, you may enrich the steam bath using your own preferred essences or suitable
scented oil sticks: remove the dispenser from its housing, as indicated, and insert one oil
stick per dispenser; or use a few drops of your preferred essence. Re-close the dispenser,
pressing it down until it locks.
The oil sticks are available from Jacuzzi® Service Centres; we advise cutting the oil stick into
two pieces, and placing one in each dispenser.
Turn on the main switch: the system will enter into "stand-by" mode and the ON/OFF
display key will light up white.
NOTE: when the appliance is powered, you must wait approximately seven minutes before
using the hammam (the thermometer symbol flashes); this time period allows the control
system to initialise the electronic management system.
Subsequent to this phase, press the ON/OFF key: it will light up blue and at the same
time, the keys associated with the programmes will turn on, those relative to the alarm
and scale removal. The display is ready to receive instructions.
NOTE:
- This mode lasts approximately one minute, after this time, if no key has been pressed, the
system reverts to "stand-by" mode.
- The activation of any key is indicated by an acoustic signal.
- If an audio kit is installed (optional), the keys relative to the audio system , will also light up
on on the display.
Select one of the three programmes and activate it by pressing one of the indicated
keys (once pressed, the key will turn blue):
WARNING: perform the following procedure if the Jacuzzi® remote control system has
been installed: press the key of the program selected, wait for it to go dim and press
again within 20 seconds.
49