Connection To The It System - Lenze R750-C Montage- Und Einschaltanleitung

Connection to the IT system

According to the relevant EMC product standard, EN 61800−3 no limit values are defined for
noise emission in the high-frequency range for IT systems.
Therefore, the technical data for EMC does not apply.
Before using the device in the IT system:
Remove the contact screw for interference suppression.
•
Position IT, TX20
-
Keep the screw for later reuse.
-
• information,
4Product
Before using the device again in other systems:
Replace the contact screw for interference suppression.
•
Screw M4 x 8 mm with a collar diameter of 10 mm
-
Tightening torque: 1 Nm (8.8 Ib-in)
-
Features
^ 44
Electrical installation
Connection to the IT system
55