Safety Instructions; Basic Safety Instructions; Application As Directed - Lenze R750-C Montage- Und Einschaltanleitung

Safety instructions

Disregarding the following basic safety measures and safety information may lead to severe
personal injury and damage to property!
Observe all specifications of the corresponding documentation supplied. This is the
precondition for safe and trouble-free operation and for obtaining the product features
specified.
Please observe the specific safety information in the other sections!

Basic safety instructions

Personnel
The product must only be used by qualified personnel. IEC 60364 or CENELEC HD 384 define
the skills of these persons:
They are familiar with installing, mounting, commissioning, and operating the product.
•
They have the corresponding qualifications for their work.
•
They know and can apply all regulations for the prevention of accidents, directives, and
•
laws applicable at the place of use.
Process engineering
The procedural notes and circuit details described are only proposals. It is up to the user to
check whether they can be adapted to the particular applications. Lenze does not take any
responsibility for the suitability of the procedures and circuit proposals described.
Device protection
The maximum test voltage for insulation tests between a control potential of 24 V and PE
•
must not exceed 110 V DC (EN 61800−5−1).

Application as directed

The product must only be operated under the operating conditions prescribed in this
•
documentation.
The product meets the protection requirements of 2014/35/EU: Low-Voltage Directive.
•
The product is not a machine in terms of 2006/42/EU: Machinery Directive.
•
Commissioning or starting the operation as directed of a machine with the product is not
•
permitted until it has been ensured that the machine meets the regulations of the EU
Directive 2006/42/EU: Machinery Directive; observe EN 60204−1.
Commissioning or starting operation as directed is only permissible if the EMC Directive
•
2014/30/EU is complied with.
The harmonised standard EN 61800−5−1 is applied.
•
The product is not a household appliance, but is only designed as a component for
•
commercial or professional use in terms of EN 61000−3−2.
The product can be used according to the technical data if drive systems have to comply
•
with categories according to EN 61800−3.
In residential areas, the product may cause EMC interferences. The operator is responsible
for taking interference suppression measures.
The regenerative module is not provided with an automatic mains isolation if the AC
•
system (ENS) fails. Thus, the regenerative module must not be used in applications that
require such an automatic mains isolation.
If the AC system fails, the DC bus (generator) is not automatically separated from the AC
system by the regenerative module.
Operation in parallel with frequency inverters with a controlled mains rectifier (Active-
•
Front-End inverter or AFE inverter) is not permissible.
Safety instructions
Application as directed
41