Troubleshooting; Specifications - Kärcher SV 1802 Betriebsanleitung

! Clean the HEPA filter regularly at inter-
vals of 4 months.
! Ensure that the HEPA filter (15) is posi-
tioned correctly in the holders. Then
block the lever (16). (Fig. 12).
Caution!
! Do not clean the HEPA filter using a
brush as it can get damaged and its filter-
ing capacity can get reduced.
! Do not use any cleaning agents, do not
rub the HEPA filter and do not clean it in
the dish-washer.
! HEPA filters are available with the au-
thorised Customer Service agents.

Troubleshooting

Often, failures have simple causes and you
can do the troubleshooting yourself using
the following overview. If you are in doubt or
if the failure is not listed here please contact
the authorized customer service.
Vacuum cleaning does not start.
There is no mains supply.
" Check the mains plug and mains socket.
Poor vacuum cleaning.
Nozzle, suction hose or suction pipe
may be blocked.
" Clean the water filter inlay. Remove
blocks, if any, from the tubes and acces-
sories.
" Change the water in the water filter con-
tainer.
HEPA filter worn out.
" Replace the HEPA filter.
Poor cleaning performance
Water in the water filter container is very
dirty
" Change the water in the water filter con-
tainer.
Water leaks out while sucking in
fluids.
The float switch is blocked.
" Clean the lid of the water filter container.
The vacuum cleaner does not suck.
Float switch is blocking.
" Switch off the vacuum cleaner, ensure
that the water level in the reservoir is cor-
rect and switch on the machine again.

Specifications

Power connection
Voltage
Kind of current
Performance data
Boiler capacity
Rated power turbine
Max. steam pressure
Heating time
per litre of water
Max. steam quantity
Filling quantity
Steam boiler
Water filter container
Water volume
Dimensions
Width
Length
Height
Weight
(without accessories)
220-240 V
1~ 50 Hz
1250 W
1050 W
4 bar
10 min
80 g/min
1,2 l
1,2 l
0,6 l
330 mm
500 mm
330 mm
8,5 kg
23
English