Setting Daylight Saving Time (Dst); Alarm Setting; Snooze Function; Receiving Measurements Automatically - National Geographic Colour Weather Center 5-in-1 Bedienungsanleitung

3. Press UP or DOWN button to select the desired time deviation in hours (-23 up to +23 hours).
4. Press the CLOCK-SET button for approx. 3 seconds to confirm the selected time deviation.

18 Setting Daylight Saving Time (DST)

To set a different time zone, proceed as follows:
1. Press the TIME button for about 3 seconds to enter the time setting mode.
2. Press the TIME button repeatedly until the daylight saving time (DST) setting flashes on the dis-
play.
3. Press the UP or DOWN button to select between AUTO (summer time on) and OFF (summer time
off).
4. Press the TIME button for about 3 seconds to confirm the setting.

19 Alarm setting

Turn on/off Alarm clock (and Ice Alert function)
1. Press ALARM button to show the alarm time.
2. Press the ALARM button again to activate the alarm.
3. Press the ALARM button one more time to activate the alarm with ice alert.
4. With activated ice alert, the alarm will sound 30 minutes earlier if outside temperature is below -3°
C.
5. To disable the alarm and ice alert, press the ALARM button until the alarm icons disappear.
Set Alarm time
6. Press and hold ALARM button for approx. 3 seconds to enter the alarm time setting mode.
7. Digits to be set are flashing.
8. Press UP or DOWN button to change the value.
9. Press ALARM button to confirm and continue to the next setting.
10. Settings order: Hours > Minutes
11. Finally press the ALARM button to save the settings and exit the setting mode.

20 Snooze function

1. When the alarm sound starts, press the ALARM/SNOOZE button to activate the Snooze function.
The Alarm will sound again after 5 minutes.
2. When the alarm sound starts, press the ALARM button or press and hold the ALARM/SNOOZE
button for approx. 3 seconds, to stop the alarm.
3. The alarm will be turned off automatically if no button is pressed within 2 minutes.

21 Receiving measurements automatically

Once power is restored, the base station will begin to display indoor readings and the first readings re-
ceived from the outdoor sensor will be displayed within approximately 3 minutes of commissioning.
If no signal is received, proceed as follows:
Press the SENSOR button for approx. 2 seconds to initiate the reception of the measured values
again.
36 / 48