Automatic Time Setting; Manual Time Setting; Display Change; Alarm Setting - National Geographic VA Colour RC Bedienungsanleitung

12. Replace the battery compartment cover.

9 Automatic time setting

After the power is restored, the unit automatically searches for the radio signal. It takes approximately
3-8 minutes for this process to complete.
If the radio signal is received correctly, the date and time are set automatically and the reception sym-
bol is displayed.
NOTICE! Some functions/buttons are deactivated during radio signal reception.
If no radio signal is received, proceed as follows:
1. Press the DOWN button on the base unit for approx. 3 seconds to activate reception of the radio
signal. Reception is now initialized again.
2. If still no radio signal is received, the time must be set manually.

10 Manual time setting

To set the time/date manually, first check whether the radio symbol in the display is still flashing (auto-
matic reception of the time signal is then still active). Now press the DOWN button to deactivate recep-
tion.
1. Press the MODE button for approx. 3 seconds to enter the time setting mode.
2. Digits to be set are flashing.
3. Press UP or DOWN button to change the value.
4. Press the MODE button to confirm and switch to the next setting.
5. Sequence of the settings: Time offset > Hours > Minutes > Year > Month > Day > Language
6. Finally, press the MODE button to save the settings and exit settings mode.

11 Display change

• In normal display mode, press the DOWN button to toggle the time display between 12-hour or 24-
hour mode.
• In normal display mode, press the UP button to toggle between °C and °F when displaying the
temperature unit.
• In normal display mode, press the CHANNEL button several times to display channels 1, 2, 3 or
automatically alternating one after another.
• NOTICE! The display of values for different channels requires the connection of several suit-
able wireless sensors (not included).
• In normal display mode, press the ALERT button several times to display the set temperature
alarm values one after another.
• In normal display mode, press the MODE button to display the set alarm times of Alarm 1 and
Alarm 2.

12 Alarm setting

1. Press the MODE button several times to select the desired alarm function: Alarm 1 (AL 1) or Alarm
2 (AL 2). The display changes to the set alarm time.
2. Press the MODE button for about 3 seconds to switch to the setting mode for the corresponding
alarm time.
3. The value to be set flashes.
4. Press UP or DOWN button to change the value.
21 / 48