Checking Oil Level - Bosch VLE 2130 Instandsetzungsanleitung

en 40 | VLE 21xx | Spindle oiler
6. Spindle oiler
6.5.1 Fitting oil tank
Contents Fitting oil tank for spindle oiler
Applicability VLE 2130, VLE 2130 F, VLE 2130 EL,
VLE 2140 EL
Special tools and Spindle oil (1 692 871 003)
other items
Fit the oil tank as follows:
1. Remove the cover over the inspection opening.
Fig. 10: Back wall of column
1 Cover for inspection opening
2. Move the lifting platform as far as the upper column
opening so that the lifting carriage comes to a halt
between the upper roller and the raising bracket.
3. De-energise the lifting platform and secure to
prevent unauthorised use.
Fig. 11: Fitting oil tank
1 Flat wick
2 Oil tank
3 Lifting carriage
|
1 689 975 224 2013-11-06
4. Fill the oil tank with oil.
5. The flat wick should be secured with a safety pin
roughly 20–25 mm above the oil tank and fitted such
that it is facing downwards. Check on installation.
6. Clamp the oil tank in position on the lifting carriage.
7. Repeat this procedure at the other column.
8. Check firm fit of oil tanks again.
Fig. 12: Lifting carriage with oiler
!
Grease renders the wick unusable.
9. Re-fit the inspection opening covers and connect up
the lifting platform again.
6.5.2

Checking oil level

Contents Checking oil level in oiler
Applicability VLE 2130, VLE 2130 F, VLE 2130 EL,
VLE 2140 EL
Special tools and Spindle oil (1 692 871 003)
other items
The oil level must be checked at regular intervals.
Proceed as follows when doing so:
1. After removing the cover for the inspection opening,
move the lifting carriage upwards until the oil tank is
visible in the opening.
2. De-energise the lifting platform.
3. Check the oil level.
4. Top up with oil if necessary.
Robert Bosch GmbH