Cutter Attachment (12) - Silvercrest SLSN 3 A1 Bedienungsanleitung Und Sicherheitshinweise


Hold the lady shaver so that
the trimmer (3) is facing the
skin and is
approximately 45°. Now run
the trimmer (3) along the area
of skin you are trimming.
Ideally, it is best to trim against
the direction of hair growth.

Once you have finished trimming the desired area of skin, push the ON/OFF switch (7) back into its
original position. The lady shaver will now stop.

We recommend cleaning the lady shaver with the cleaning brush (14) after every shave. For details
on how to clean the lady shaver more thoroughly, please refer to section '9. Cleaning/maintenance'.

8.4 Cutter attachment (12)

The cutter attachment (12) should be used if you just want to shorten hair or trim the bikini line.

Pull the protective cover (1) upwards.

Place the cutter attachment (12) onto the lady shaver from the top and push it downwards until you
hear it click into place. When putting on the attachment, ensure that the recess for the trimmer locking
mechanism (4) is on the right-hand side.

Slide the ON/OFF switch (7) towards the shaving foil (2) while pressing the travel safety lock (8). The
lady shaver will now start.

Run the lady shaver in straight lines over the area of the hair you wish to trim. Keep repositioning the
lady shaver, moving it slowly against the direction of hair growth.

Once you have finished on the desired area of skin, push the ON/OFF switch (7) back into its
original position. The lady shaver will now stop.
angled at
SilverCrest SLSN 3 A1
English - 33