Vaisala HMDW110 Serie Kurzanleitung Seite 8

2. Open the transmitter cover, and route the cable through the cable gland.
Connect the wires to the screw terminals according to the wiring
instructions:
Wiring HMDW110 on page 10
o
Wiring HMDW110 with RDP100 on page 11
o
For the arrangement of the screw terminals, see section Component
Board on page 9.
3. Tighten the cable gland and close the transmitter cover.
4. Remove the yellow transport protection cap from the probe.
HMS110/112 Installation
n
n
n
n
Additional tools for pole installation:
n
Additional tools for wall installation:
n
n
n
6
Medium size crosshead screwdriver (Pozidriv).
Small slotted screwdriver for screw terminals.
Tools for cutting and stripping wires.
19 mm open-end wrench for tightening the cable gland.
Zip ties for securing the cable to the pole.
Drill and bits.
Screws (2 pcs, Ø < 5.5 mm) and wall plugs.
Cable clips for securing the cable to the wall.