Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Component Board
All HMDW110 transmitter models use the same component board and have two
4 ... 20 mA outputs (loop powered). There is also a service port for configuration
and calibration use.
1 =
Terminal block for 4 ... 20 mA current loop outputs.
2 =
Service port connector (4-pin M8).
3 =
Terminal block for RS-485 output to RDP100 display panel (optional).
You can pull out the terminal blocks from the component board
for easier installation, and to disconnect the transmitter from
power and RS-485 when using the service port.
EN
DE
FR
JA
ZH
RU
9
Werbung
