Vaisala HMDW110 Serie Kurzanleitung Seite 15

1. Open the cover of the HMDW110 series transmitter.
2. If the terminal block for terminals 5 ... 8 is wired, pull it out. This
disconnects the transmitter from supply voltage and prevents possible
equipment damage that may be caused by ground loops. The locations of
the terminal blocks and the service port are shown in section Component
Board on page 9.
3. If the other terminal block is wired (terminals 1 ... 4), pull it out also. This
prevents the communication between the transmitter and RDP100 remote
display panel from interfering with your connection.
The default serial line settings of a HMDW110 series
transmitter are 19200 8 N 1. These settings are needed for
compatibility with the RDP100. If you are not using the display,
you can change the settings using the seri command. Note
that the service port settings will also change.
You can download the PuTTY terminal program from
www.vaisala.com.
EN
DE
FR
JA
ZH
RU
13