Sensor Visualization - Selve commeo Multi Send Betriebsanleitung

GB Programming
8.6.7. Sensor visualization
With the sensor visualization measured values of a commeo Sensor WS/WSRF can be
shown in the display. Also the daylight condition of the selected receiver is shown in
the graphics.When visualization is switched on, the notification can be called up in
operation mode by pushing the left display button for 1 second. By pushing of one of
the two display buttons you will get back into the operation mode.
To show the values, a receiver in which a sensor is programmed has to be selected in
the menu Sensor visualization.
Examples for the notification on the display in the sensor visualization
Explanation of symbols
Radio connection to the sensor
The symbol signals that the connection to the receiver has been established
and that there is no problem with the sensor so that all data are up to date.
S1–S3 Measured light values of the sun sensors
The three measured sun values will be shown in klx, for values below 1000 lx
only a light value will be shown.
Measured wind value
Display of the currently measured wind speed in m/s.
Wind alarm
The symbol signals that there is a wind alarm in the receiver.
Frost alarm
The symbol signals that there is a frost alarm in the receiver.
Daylight condition of the receiver
T he graphics show the current daylight condition of the receiver (sunny,
cloudy, night, including rain and when frost snow)
sunny
rain and frost alarm
Measured temperature
The currently measured temperature in the housing of the sensor will be
shown in °C. At strong direct sunlight the value may be distorted. Tempera-
tures above 30 °C will not be shown.
cloudy
night
56
rain