Intermediate Position 2; Select Button/Prog Button; T Ransmitter Programming Procedure - Selve commeo Multi Send Betriebsanleitung

GB Explanation of functions
7.7. Intermediate position 2
The intermediate position is a position between the upper and lower end limits that can
be freely selected.
Set intermediate position 2:
Operation
>3 s
Travel to intermediate position 2:
Operation
2x
7.8. SELECT button/PROG button
The SELECT button and PROG button are meant for teaching in and setting the
re c eivers. The instructions can be taken from the receiver/motor manual.
7.9. T ransmitter programming procedure
The instructions can be taken from the receiver/motor manual.
Drive
Move the drive to the lower end position with the
DOWN button.
Push the STOP button and then additionally push the
UP button. Keep both pushed.
After 3 seconds, the programming run starts.
Set the position with the UP and DOWN buttons while
keeping the STOP button pushed.
Releasing the STOP button will save the position.
Drive
Push the UP button twice quickly in sequence.
44