Klarstein Valeria Handbuch Seite 25

Activated carbon filter
1 Before installing the activated carbon filter, first remove the grease filter. Press the
lock and remove the grease filter.
2 Slide the activated carbon filter into the rectangular hole below the engine until it
clicks into place at the rear of the rectangular hole. Raise the two fixing rails until
they are horizontally above the carbon filter.
3 Then reinsert the grease filter.
4 To remove the activated carbon filter, proceed in reverse order.
Replacing the bulb
• The bulb must be replaced by the manufacturer, its customer service or similarly
qualified persons.
• Always turn off the power before performing any work on the unit. When handling
the bulb, make sure it is completely cool before touching it directly with your hands.
• When inserting or removing the bulb, always hold it with a cloth or gloves to ensure
that sweat does not come into contact with the bulb, as this may shorten the life of
the bulb.
EN
25