Klarstein Valeria Handbuch Seite 20

EN
20
8 Hold up the hood, 16 M4*10 big flat screws will be used to connect the hood
body into angle iron, see pic 6.
9 Put the extendable pipe on the outlet,see pic.7. After ensuring everything is ok,
put down the hook and the external chimney, then the installation is complete,
see pic 8.
INSTRUCTIONS FOR INSTALLING
THE EXHAUST PIPE
The following rules must be strictly adhered to in order to achieve optimal air extraction:
• Make sure that the exhaust pipe is as short and straight as possible.
• Do not reduce the size and do not restrict the exhaust pipe. When using exhaust
pipes, the pipe must always be laid tightly in order to minimize the pressure loss.
• Failure to follow these basic instructions will reduce performance and increase the
noise level of the cooker hood.
• All installation work must be carried out by a qualified electrician or other qualified
person.
• Do not connect the exhaust pipe of the hood to an existing ventilation system that is
used for another unit, such as a ventilation system, such as a flue, gas pipes or hot
air pipes.
• If the exhaust pipe makes a bend, the angle of the exhaust pipe should not be
less than 120 °. Never align the exhaust pipe downwards, but always align it
horizontally or guide the pipe from the starting point upwards to the air outlet on the
outer wall.
• After installation, make sure that the cooker hood is horizontal so that no grease
can accumulate.
• Make sure that the exhaust pipe selected for the installation complies with the
relevant standards and is fire resistant.