Use And Operation; Hints On Disposal; Declaration Of Conformity - Klarstein 10030847 Anleitung

Remote Control and Functions
Power
Heater off
Heater I/II
Flame
As an Important safety feature, the heating element Is designed with a delayed activation sequence. Therefore,
when the heater is turned on it will take several seconds for the unit to begin blowing hot air. Subsequently, the
fan blower will continue to run.
According to the European waste regulation 2012/19/EU this symbol on the product or on
its packaging indicates that this product may not be treated as household waste. Instead
it should be taken to the appropriate collection point for the recycling of electrical and
electronic equipment. By ensuring this product is disposed of correctly, you will help pre-
vent potential negative consequences for the environment and human health, which could
otherwise be caused by inappropriate waste handling of this product. For more detailled
information about recycling of this product, please contact your local council or your
household waste disposial service.
Producer: Chal-Tec GmbH, Wallstraße 16, 10179 Berlin, Germany.
This product is conform to the following European Directives:
2014/30/EU (EMC)
2014/35/EU (LVD)
2011/65/EU (RoHS)
29

Use and Operation

Press this button to turn the unit on. To turn it
back to standby mode, press it again.
This button will tum off the heater and
blower.
This button will tum on the power to the
heater and blower. The HEATER switch has
two options Heater I and Heater II. Hater I
button will activate the heater on the low
setting (750 W). Heater II button will activate
the heater on the high setting (1500 W).
Allows you to adjust the flame to suit your
mood. Press button [+] to increase flame
brightness and press [-] button to decrease
flame brightness. You must press the button
[+] several times to see the full flame effect.

Hints on Disposal

Declaration of Conformity