BEARWARE 302547 Bedienungsanleitung Seite 76

8. Basic settings:
Note: Firmly touching the top of the housing will switch on the backlight.
After the "SNOOZE/SLEEP" button is released, it switches off again after 5
seconds. Please note that the base station does not respond to 2 buttons at
the same time. It is therefore advisable to press only one button.
Press and hold the "SET/HISTORY" button for about 3 seconds to configure the
basic settings. With the "UP" and "DOWN" buttons, you can change the values
accordingly.
By briefly pressing the "SET/HISTORY" button in the time settings, you can confirm
entry and proceed to the next option. In this way, you can change and customise
the following settings in the sequence mentioned below:
• Year
• Month
• Day
• Language setting - To set the day on the display. The following
codes can be configured and selected using the "UP" and "DOWN"
buttons: GE (German), DA (Danish), ES (Spanish), NE (Dutch), FR
(French), IT (Italian), EN (English)
• 12 or 24 hour display
• Hour
• Minute
• Time zone - Note: If you set the time zone, for example, to + 01
and the weather station is actuated using the DCF-signal, then the
clock displays one hour later than the DCF-signal.
• Weather forecast - The weather station calculates a weather
forecast based on changes in the air pressure. Since data regard-
ing changes in air pressure is not available when the device is
switched on for the first time, the weather forecast at this time is
incidental. The weather station will be able to calculate a forecast
only after a couple of days. To do this, select a forecast using the
"UP" and "DOWN" buttons. It is best to select a forecast from the
current weather report.
• Atmospheric pressure - The atmospheric pressure is displayed
in "mb" or "hPa" depending on the setting. You can now set the
display to the barometric air pressure of your location. Use the
atmospheric pressure data of your location from the Internet or
76
English