BEARWARE 302547 Bedienungsanleitung Seite 79

9. Stored data
Maximum and minimum temperatures
Press the "MEM" button to view the maximum indoor and outdoor temperatures
as well as the maximum humidity. The respective maximum readings are now
shown on the display. Press the "MEM" button again to view the minimum meas-
ured values. After 5 seconds, the current reading is displayed.
Note: The min/max temperatures are measured from the total operating
time of the weather station. Press and hold the "MEM" button for about 3
seconds to delete the stored maximum/minimum values.
Atmospheric pressure
By pressing the "SET/HISTORY" button briefly and repeatedly, you can view the
atmospheric pressure of the last 12 hours. The number in the "HIST" display
indicates the hour.
10. Additional settings
DCF signal
The base station synchronises the internal clock every night with the DCF signal.
To receive the DCF signal manually, press and hold the "DOWN" button for 3
seconds, until the following symbol appears in the display and flashes: " ". When
the signal is received successfully, the symbol will glow continuously. If the signal
is not received, the symbol disappears.
Receiving the signal external sensor
The outdoor sensor sends a signal twice a minute, which is automatically received
by the base station. You can also manually enable the signal reception. To do this,
press and hold the "CH" button for about 3 seconds until the channel symbol ("
") starts flashing. Once the signal has been successfully received, the anima-
tion of the symbol disappears and the received temperature and humidity is
shown on the display of the weather station.
English
79