BEARWARE 302547 Bedienungsanleitung Seite 70

5. Commissioning
Take the product out of the package and remove all the packaging material. Open
the battery compartment of the outdoor sensor and insert two 1.5V AA batteries.
Then open the battery compartment on the back of the main unit and insert two
1.5V AA batteries. Alternatively, you can use the supplied 4.5V/150mA coaxial pow-
er adapter for operation. For this purpose, plug the mains adapter into a properly
installed socket and then connect it to the coaxial connector of the main unit.
Note: If you want to use the device with batteries, then the backlight is
not permanently switched on. The backlight of the display is continuously
switched on only when operated with the enclosed power adapter.
The weather station then attempts to establish connection with the outdoor sen-
sor. Make sure that both devices are within each other's range. The connection
symbol " " flashes in the "Outdoor temperature display" of the main unit. If the
main unit cannot establish a connection with the outdoor sensor within 3 minutes,
then it stops searching. The connection icon stops flashing and the temperature
display shows "-._°C" and "-._%" on the display.
In most cases, the connection cannot be established due to specific factors such
as reinforced walls or a too great distance between the sensor and the main unit.
In this case, position the sensor and the main unit closer to each other. To restart
scanning, press and hold the "CH" button on the back of the main unit for 3 sec-
onds until the connection symbol in the display starts flashing.
6. DCF signal
The DCF signal is a time signal which is sent out by one of the most accurate clocks
in the world. It is located near Frankfurt am Main. Under ideal conditions, your
weather station can receive this signal from a distance of up to 1500 km.
If the weather station has detected the signal, then it displays Central European
Time, the date, and the day of the week. The DCF symbol " " is then shown in
the display.
70
English