Using The Lcd Monitor - Waeco PerfectView M35L Montage- Und Bedienungsanleitung

_M35L.book Seite 26 Montag, 8. Dezember 2008 2:57 14

Using the LCD monitor

Note
I
Cables and connections which are not properly installed will cause malfunctions
or damage to components. Correct installation of cables and connections is the
basic prerequisite for lasting and trouble-free operation of the retrofitted compo-
nents.
To prevent damage to the cables, when laying them ensure that there is sufficient
distance to hot vehicle components (lights, heaters, ventilators etc.).
Wrap insulating tape around every connection on the cable (even inside the vehicle).
When laying electric connections, ensure that
– They are not kinked or twisted,
– They do not rub on edges,
– They are not laid in sharp edged ducts without protection (fig. 3, page 4).
➤
Lay the monitor cable on the dashboard.
➤ Insert the plug of the monitor cable (fig. d 2, page 8) into the socket of the connec-
tion cable (fig. d 4, page 8).
Warning!
e
Make sure the polarity is correct when connecting to a voltage source.
➤
Connect the two loose cable ends of the connection cable to a suitable voltage
source:
– Connect the red cable (fig. d 5, page 8) to terminal 15 (ignition) or to the positive
cable of the reverse headlight.
– Connect the black cable (fig. d 6, page 8) to terminal 31 (earth).
➤
Plug the cinch socket of the connection cable (fig. d 4, page 8) together with the
cinch plug (fig. d 8, page 8) of the video source (RV-29-T130).
7 Using the LCD monitor
7.1 Switching on the monitor
➤
Set the "Power Off/On" sliding switch (fig. 7 3, page 5) to "On" to switch on the mon-
itor.
✓
The picture of the video source appears.
7.2 Switching off the monitor
➤
Set the "Power Off/On" sliding switch (fig. 7 3, page 5) to "Off" to switch off the mon-
itor.
✓
The picture of the video source disappears.
26
PerfectView M35L