Waeco PerfectView M35L Montage- Und Bedienungsanleitung Seite 25

_M35L.book Seite 25 Montag, 8. Dezember 2008 2:57 14
PerfectView M35L
Ensure that you can lay the monitor cable.
When attaching the monitor with the installation clip, you can use existing openings
such as ventilation slots.
If you wish to attach the monitor to the monitor holder, proceed as follows:
➤
Attach the monitor holder (fig. b 2, page 7) to the desired location.
➤
Attach the monitor on the fastening rails (fig. b 2, page 7) directly on the magnets
of the monitor holder.
➤
Turn the joint of the monitor holder in the desired position.
If you wish to attach the monitor to the installation clip, proceed as follows:
➤
Attach the installation clip (fig. c 2, page 8) to the desired location.
➤
Push the monitor and the mounting rail (fig. c 1, page 8) onto the installation clip
(fig. c 2, page 8).
6.3 Establishing the electrical connection for the monitor
The circuit diagram for the LCD monitor can be found in fig. d, page 8.
No. in
Description
fig. d, page 8
1 Monitor
2 4 pin mini-DIN plug
3 Connection cable
4 4 pin mini-DIN socket
5 12 V positive cable (red): connection to the positive pole of the
voltage source
6 Earth cable (black): connection to the negative pole of the
voltage source
7 Cinch connection (connection to video source)
8 Cinch plug from the video source e.g. camera
Observe the following instructions when laying out the connection cable:
Note
I
Feed the connection cable through existing ducts or other openings where pos-
sible e.g. ventilation grids. If no appropriate ducts or openings are available you
will need to drill a hole of Ø 20 mm. Check beforehand that there is sufficient
room for the drill head to come out on the other side (fig. 2, page 4).
Installing the LCD monitor
25