Using The Lcd-Monitor - Waeco PerfectView M170L Montage- Und Bedienungsanleitung

PerfectView M170L
Observe the following instructions when laying the connection cable:
Note
I
Feed the connection cable through existing ducts or other openings where pos-
sible e. g. ventilation grilles. If no appropriate ducts or openings are available
you will need to drill a hole of ∅ 20 mm. Check beforehand that there is sufficient
space on the other side for the drill head to come out (fig. 2, page 4).
Note
I
Please observe the notes from the chapter "General information on the electrical
connections" on page 30
➤ Lay the monitor cable on the dashboard.
➤ Insert the plug of the monitor cable (2) in the socket (4) of the connection cable (3).
Caution!
e
Make sure the polarity is correct when connecting to a voltage source.
➤ Connect the red and black cables of the connection cables to a suitable
voltage source:
– Connect the red cable (5) to terminal 15 (ignition).
– Connect the black cable (6) to terminal 31 (earth).
➤ If necessary, connect the mini DIN socket (7) of the connection cable to the
mini DIN plug (10) of the system cable (11).
➤ Connect the mini DIN socket (12) of the system cable (11) of to the mini DIN plug (13)
of the camera cable.
➤ Connect the green cable (9) to the positive cable of the reversing light.
Note
I
If a voltage is present on the green cable, the monitor is switched on automati-
cally and the camera is activated.
8

Using the LCD-monitor

8.1 Switching on the monitor (fig. d, page 8)
Note
I
The monitor is switched on automatically, if you shift into reverse gear. The
image is transmitted by the camera.
➤ If the monitor is switched off, press the "Power" main switch (5), to switch the monitor
on.
✓ The picture appears.
Using the LCD-monitor
35