Using The Lcd Monitor; Cleaning And Maintaining The Lcd Monitor - Waeco PerfectView M511L Montage- Und Bedienungsanleitung

Using the LCD monitor

7 Using the LCD monitor
7.1 Switching on the monitor
➤
If the monitor is switched off, press the "
monitor on.
✓
The picture of the video source appears.
7.2 Switching off the monitor
➤
Press the "
itor off.
✓
The picture of the video source disappears.
7.3 Setting the monitor
To set the monitor to suit your requirements, proceed as follows:
➤
With the monitor switched on, briefly press the "
the required parameters.
✓
The parameters are displayed in the following sequence:
– Brightness
– Colour
– Contrast
– Tint
– Volume
➤
Press the button (0 2, page 6), to reduce the value of the selected parameter.
➤
Press the button (0 3, page 6), to increase the value of the selected parameter.
7.4 Setting the video source
➤
If you wish to switch to a different video source (from video 1 to video 2), press the
"V1/V2" button (b 10, page 7) on the remote control or the monitor (0 5, page 6).
✓
The monitor switches from video source 1 to video source 2 and vice-versa.
If you have connected the green cable to the reversing light and a voltage is
present, video source 2 is activated automatically.
8

Cleaning and maintaining the LCD monitor

Caution!
Do not use sharp or hard objects for cleaning as these may damage
the monitor.
Remove the cable before cleaning the monitor to prevent short circuiting.
➤
Clean the monitor with a soft, damp cloth from time to time.
30
/M
" button (0 3, page 6) for longer than 2 seconds to switch the mon-
/M
" button (0 1, page 6) to switch the
/M
" button (0 1, page 6) to set
PerfectView M511L